Skip to main content

Report this content

We want the Dreams coMmunity to be a safe, diverse and tolerant place for everyone, no matter their age, gender, race, sexual orientation or otherwise. If you believe this content to contradict these principles, you can file a report for our coMmunity teams to investigate.

Note that misuse of the reporting tool will not be tolerated.

Item being reported:

A forum post by Skn3--

I am trying to start a signal manipulator from an offset specified by a value in a wire. E.g. 50%. I want the signal manipulator to continue from this starting offset and then loop as normal.

So I can do this manually by changing the slider in the tweak menu. However I can’t do this with an input wire because it permanently overwrites the “current” position of the signal manipulator.

I basically have some logic that calculates the starting offset of the signal manipulator based on the distance from another point. So this value has to be able to be set dynamically.

Any ideas?

Oh dear! Your browser is either unsupported, or there has been a problem loading the page.