Report this content
We want the Dreams coMmunity to be a safe, diverse and tolerant place for everyone, no matter their age, gender, race, sexual orientation or otherwise. If you believe this content to contradict these principles, you can file a report for our coMmunity teams to investigate.
Note that misuse of the reporting tool will not be tolerated.Item being reported:
First thing is to make sure the controlle sensor is at the centre of the marble. That way the camera will pivot around the centre of the ball. To do this you can turn the grid on, cut the ball in half using a subtractive edit, stick the microchip right at the centre of the marble (L1 while moving the microchip/gadget) , and then delete the subractive edit.
The next thing is to set up the mover correctly. Its quiet complicated but the simple answer is
- split the left stick output of from the controller Sensor (page 2),
- split this output so that you have X & Y values,
- plug these into the X & Z speed inputs on an advanced mover,
- remove all damening on the advance mover.
Hope this helps - Peter