Report this content
We want the Dreams coMmunity to be a safe, diverse and tolerant place for everyone, no matter their age, gender, race, sexual orientation or otherwise. If you believe this content to contradict these principles, you can file a report for our coMmunity teams to investigate.
Note that misuse of the reporting tool will not be tolerated.Item being reported:
For me, a Counter would be a simpler solution, rather than a Signal Manipulator.
Configure the Counter with a starting value of 0 and a target count of 1. Take a wire from the 'square' output in the Controller Sensor and connect the to the Counter, to make it add. Finally, connect a wire from the 'Counter Full' output into your trigger.
Now when you press square it'll increase the count of the Counter causing it to activate and provide power to turn on your trigger.
If you need to turn it off, then just wire the appropriate logic into 'Reset Count'.