Report this content
We want the Dreams coMmunity to be a safe, diverse and tolerant place for everyone, no matter their age, gender, race, sexual orientation or otherwise. If you believe this content to contradict these principles, you can file a report for our coMmunity teams to investigate.
Note that misuse of the reporting tool will not be tolerated.Item being reported:
Question for you - Why do you have a fat wire going in to the signal input? If all you want is a value of on and off can you simplify that to a single wire using a splitter? I just tried inputting a Fat wire of (1,0,0) to a SM and can't make sense of the number that came out (1.7 for some reason )
Have you enabled any Blend Modes on your input wires? A blend mode of 'Blend' with inputs of 1, 0, 0 would output .3 as this is the weighted average. This doesn't seem to apply to fat wire input, just multiple input wires. Still worth a check as it's easy to overlook.
Worth also checking that 0.01% of a chance! Wire up a number displayer, set it to 2 decimal places and wire it up to the same value the signal manipulator is receiving. Activate your Trigger zone in Edit mode and if the number displayer is selected you'll see what the value is.