Report this content
We want the Dreams coMmunity to be a safe, diverse and tolerant place for everyone, no matter their age, gender, race, sexual orientation or otherwise. If you believe this content to contradict these principles, you can file a report for our coMmunity teams to investigate.
Note that misuse of the reporting tool will not be tolerated.Item being reported:
Hover over the little tab that appears near the input for the setting. It should look like a little blob pointing right. This means the input blend mode is "override", and will set the value directly.
There are two other input blend types: "blend" (looks like a 0) which averages all wires coming in and then sets the value. And "modulate" (looks like an X) which takes the highest value it's receiving from any connected wires and multiplies the setting's value by that value.
And you can cycle through them with L1 + X. And while holding L1, the tooltip will explain what that input blending mode does.
As @daniel-hamster mentioned, I'm guessing it's on modulate mode. This is the default when wiring into a setting that has a non-zero value.